Endress+Hauser nivocompact FTC 731 Installation And Operating Manual page 13

Installation
The housing can be rotated if the cable gland is facing in the wrong
direction after the Nivocompact has been securely screwed in:
Loosening
• Unscrew and remove the housing cover
• Loosen the central screw in the electronic insert
• Remove the plug-in electronic insert from the housing using the handle
• Slightly loosen the 3 screws in the housing, see Fig. 9.
Rotating
• The housing can now be rotated through 360°.
When mounting an FTC 731 laterally, the cable gland should point
downwards so that no moisture can enter
Tightening
• Tighten up the 3 screws in the housing so that the housing is well sealed
at the hex nut
• Insert the electronic insert in the plug
• Securely tighten the central mounting screw
while making sure that the cable gland remains free
Rotating the Housing
Fig. 9
Loosening and rotating the housing.
Fig. 10
Tightening the electronic insert.
11