Using Your Radio - Cobra microTALK CXR900 Owner's Manual

Using Your Radio

Introduction
Intro Operation Customer
For charging microTALK
Insert Radio(s)
Assistance
charger:
1. Insert radio(s) into desktop charger as shown.
2. Insert round connector of 120-volt adapter
into jack on back of charger.
3. Plug 120-volt adapter into electrical outlet.
Secondary Icons
If charging light is not on, check position of
radio. Radio should be upright. The charge
o Operation Customer Warranty
indicator light will stay on as long as the radio is in the charging
Assistance
well and the battery pack is charging. After the battery pack is fully
charged, the charge indicator light will turn off.
It normally takes about 15 hours to fully recharge battery pack.
Notice
Battery pack will not be damaged if it stays in the charging well
ons
longer than that.
To charge a single radio, you can bypass the desktop
charger and simply insert the wall adapter's round
connector directly into the speaker/microphone/charge
Notice jack located on the top of the radio.
cons Use only the supplied rechargeable batteries and charger for
recharging your Cobra microTALK ® radio.
Cobra recommends your radio is turned off while being charged.
Quick Start
1. Press and hold the Power button
to turn on your radio.
2. Press the Channel Up or Channel Down
button to select a channel.
Intro Operation Customer
Assistance
Both radios must be tuned to the
same channel/privacy code to
communicate.
3. Press and hold the Talk button while
speaking into the microphone.
4. When finished talking, release the Talk
button and listen for a response.
dary Icons
2
Introduction
Warranty
® radio(s) in desktop
On/Off Power
Battery Low
Battery Save Mode
Main Icons
Talk Button
Two Inches (5 cm)
from Mouth
Secondary Icons
Warranty
Operation Customer Assistance Warranty
Intro Operation Customer Warranty
Turning on Your microTALK ®
Assistance
Press and hold the Power button until you
hear a series of audible tones indicating the
radio is on.
Your microTALK ® radio is now in Standby
mode, ready to receive transmissions. The radio
Secondary Icons
is always in Standby mode, except when the
Talk, Call, Mode or Power buttons are pressed.
Battery Low
When battery power is low, the Battery Low icon
will blink. Your batteries should be recharged.
Notice
Auto Battery Save
Your microTALK ® radio has a unique circuit
designed to extend battery life. If there are
no transmissions for 10 seconds, the radio will
automatically switch to Battery Save mode and
the Power Saver icon will flash in the display.
This will not affect the radio's ability to receive
incoming transmissions.
Communicating with Another Person
1. Press and hold the Talk button.
2. With the microphone about 2 inches
Intro Operation Customer Warranty
Assistance
(5 cm) from your mouth, speak in a
normal voice.
3. Release the Talk button when you are
finished talking and listen for a response.
You cannot receive incoming calls while
pressing the Talk button.
Both radios must be tuned to
the same channel/privacy code
to communicate.
Notice
Radio
•
•
•
•
LI 7300
3