Minelab EQUINOX 900 Instruction Manual page 45

Wireless Headphones
ML 85 WIRELESS HEADPHONES
Minelab ML 85 Low Latency Wireless headphones are
supplied with your detector� ML 85 headphones can also be
used as wired headphones — see
page 46�
For detailed information on pairing and other headphones
controls and functions, refer to the instructions supplied
with the headphones�
The instructions can also be downloaded at
com/support/downloads/product-manuals-guides
Minelab ML 85 Wireless Headphones
PAIR WIRELESS HEADPHONES
1. Long-press (2 seconds) the Wireless Audio button on
the detector to enter Wireless Pairing mode�
The Wireless Audio button
2. Press-and-hold the Multi Function Button (the centre
button) on the ML 85 headphones until the LED flashes
red and blue�
3. Your headphones will connect automatically — the
Wireless Audio Indicator on the detector will remain
on, and the LED on the headphones will flash blue once
every 3 seconds�
If no connection is made within 5 minutes, Wireless
Audio will automatically turn Off�
CONTENTS
"Wired Headphones" on
www�minelab�
45
RE-CONNECT PREVIOUSLY PAIRED
HEADPHONES
Previously paired headphones automatically re-connect�
1. Press the Wireless Audio button to turn Wireless On�
The Wireless Audio button
2. Press the Multi Function Button (the centre button) on
the ML 85 headphones to turn them On�
3. The headphones will re-connect automatically�
WIRELESS AUDIO INDICATOR
The Wireless Audio Indicator appears on the display when
Wireless Audio is On� It displays the current Wireless Audio
connection status depending on its display state�
The Wireless Audio Indicator
Rapid flashing: Wireless Pairing mode is enabled and
searching for nearby wireless headphones�
Solid on: Wireless headphones are paired and connected�
Slow flashing: Attempting to re-connect to headphones
that were previously paired�