Advertisement
Figure 4
1. Route the wire harness
under the cab
5. Install the harness connectors to the main harness
(Figure
5).
Note: One connector in the wire harness is not used
for this kit
(Figure
5).
Figure 5
1. Connectors
g025945
2. Use the cable ties to
secure the harness
2. This connector is not used
for this kit.
6. Secure the harness under the cab to the main harness
with the cable ties.
7. Install the kick plate and foot plate.
Checking the Alarm
•
Check and ensure the alarm is working by turning the
ignition key to on (do not start the machine) and push the
traction pedal to the reverse position.
•
With the ignition key on, move the traction joystick in
the reverse direction.
Note: The alarm should sound when the joystick and
traction pedal are activated. It if does not sound, ensure
the software is updated to revision G or higher and the
harness connections are secure.
3
Advertisement
