Programming Memory Locations - Cobra MicroTalk How To Use Manual

310WX.MANUAL.qx copy 6/17/99 12:18 PM
Advanced Features
Programming

Programming Memory Locations

Memory
Your MicroTalk has 10 memory (0-9) locations for
Locations
storing your most frequently used channels.
Rotate ON - OFF Volume Control
1
An audible "tone" will indicate the unit is on
and then the LCD will go through a 3 second
self-test and then go to operational mode.
Push and release
2
a memory location flashes.
Select memory location you wish to change by
3
pushing and releasing
MEM 6 for this example).
24
Page 24
clockwise.
button until icon and
buttons (Use
Advanced Features
Push and release button again.
4
MAIN CHANNEL will flash and only the
icon will remain flashing.
Select desired main channel you wish to store
5
(1-14) by pushing and releasing
buttons. (Use CHANNEL 12 for this example.)
Note
Once you enter memory
mode you can talk and lis-
ten to any channel you
select after programming is
complete. See Using
Memory Locations section
on page 28.
continued
25