Canon EOS 55 Service Manual page 100

Part 3: Repair Information
ASSEMBLY
&
DISASSEMBLY NOTES
I
NOTE
■
:
Discharge the main flash capacitor!
Always drain the main flash capacitor as soon as the top cover is removed.
I
NOTE
■
:
Front Cover (3) Removal
Loosen, but do not remove, the screws holding the back cover latch cover. This cover
does not need to be removed for most work.
I
NOTE
II :
Top Cover (7) Removal
1. Remove the four eyepiece screws (2 black, 2 chrome).
2. Remove the screw at the right end strap lug.
3. Lift the top cover. Disengage the grip clip from the top cover clip hole before removing
the top cover.
4. Discharge the main capacitor!
5. Unsolder the five leads from the camera as shown
in
Figure 3-12.
6. Disconnect the flash connector.
Fig. 3-12 Lead Wiring and Main Capacitor Bleeding
I NOTE
II :
Bottom Cover Installation (EOS 55 only)
When reinstalling the bottom cover, insure that the Panorama lever in the cover and the
panorama switch are properly coupled.
3-9