NOTE FOR REPAIR
• Make sure that the flat cable and flexible board are not cracked or bent at the terminal.
Do not insert the cable insufficiently nor crookedly.
• When remove a connector, do not pull at wire of connector. It is possible that a wire is
snapped.
• When installing a connector, do not press down at wire of connector.
It is possible that a wire is snapped.
• Do not apply excessive load to the gilded flexible board.
UNIVERSAL WRENCH
When disassembling or assembling Front Barrel A, use the specified jig for name ring wrench (49mm).
Name ring wrench
(49mm):
J-6082-586-A
SERVICE TOOLS
Grease (G-85):
J-6082-626-A
G-85
Grease (SG-310):
9-913-200-36
SG-310
SEL16F28 (E 16mm F2.8)
2. DISASSEMBLY
Cut and remove the part of gilt
which comes off at the point.
(Be careful that some
pieces of gilt may be left inside)
2-1