Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Hover-1 MY FIRST FORKLIFT
Summary of Contents for Hover-1 MY FIRST FORKLIFT
- Page 1 MY FIRST FORKLIFT OPERATION MANUAL H1-FLFT...
- Page 2 HELMETS SAVE LIVES! Always wear a properly fitted helmet that complies with CPSC or CE safety standards when you ride. Incorrect Fit: Correct Fit: Forehead is exposed and Make sure your helmet vulnerable to serious injury. covers your forehead.
-
Page 3: Table Of Contents
INTRODUCTION This manual is designed to give you the information you need for the safe operation and maintenance of your Hover-1 My First Forklift. Please read it thoroughly before operating your My First Forklift. WARNING TABLE OF CONTENTS PAGES My First Forklift Diagram Make sure you read this complete manual before operating your My First Forklift. -
Page 4: My First Forklift Diagram
MY FIRST FORKLIFT DIAGRAM 1. Front Fork 2. Fork Frame 3. Front Fork Link 4. Front Fork Lift 5. Lever 6. Headlight 7. Roof 8. Seat 9. Door Frame 10. Trunk Lid 11. Door Please visit 12. Rear Wheel www.hover-1.com/troubleshoot 13. -
Page 5: Parts List
PARTS LIST (2) Front Fork Links (2) Front Wheels Drive Gear (4) Wheel Covers (2) Rear Wheels (2) Door Frames (1) Charging Cable (1) Screwdriver (1) Remote Control (2) Levers (2) Spanners... - Page 6 PARTS LIST (1) Body (1) Front Fork Lifter (1) Roof (1) Fork Frame (1) Trunk Lid (1) Toy Pallet (1) Trunk (1) Seat (4) Wheel Covers (2) Front Forks...
-
Page 7: Assembly
CARE & MAINTENANCE ASSEMBLING YOUR MY FIRST FORKLIFT Large Medium Large Medium... - Page 8 ASSEMBLING YOUR MY FIRST FORKLIFT Medium Medium Once a fork is attached, slide Attach each fork at it to the side the middle of the lift. and repeat. Attach the top piece of the fork, then the bottom piece.
- Page 9 CARE & MAINTENANCE ASSEMBLING YOUR MY FIRST FORKLIFT Small...
- Page 10 CARE & MAINTENANCE ASSEMBLING YOUR MY FIRST FORKLIFT Note: Before installing the seat, connect the red wire to the battery socket.
- Page 11 CARE & MAINTENANCE ASSEMBLING YOUR MY FIRST FORKLIFT Large Note: As you install the doors, you will need to connect the wiring under the front fenders.
- Page 12 CARE & MAINTENANCE ASSEMBLING YOUR MY FIRST FORKLIFT The charging port is located near the seat. Make sure you charge the forklift while it is turned o . Fully charge the battery before your rst use. Small The charger will light up green when the forklift is fully...
- Page 13 CARE & MAINTENANCE ASSEMBLING YOUR MY FIRST FORKLIFT The My First Forklift should look like this when the assembly process is complete. Press the red power button to turn it on and get started!
-
Page 14: Controls
CONTROLS PAIR REMOTE TO FORKLIFT If the remote is not pairing to the forklift, follow these instructions: 1. Turn o the forklift and remove the batteries from the remote, then put the batteries back in. 2. Press and hold the code button on the remote while turning on the forklift. 3. -
Page 15: Riding Your My First Forklift
RIDING YOUR MY FIRST FORKLIFT Ensure your Hover-1 My First Forklift is fully assembled and correctly installed with screws secured tightly in place. Failure to do so may result in damage to the vehicle and serious bodily harm or death. -
Page 16: Care & Maintenance
• While charging, the charger will warm up. If the charger does not warm up, the charger, battery, or circuit may have failed. 1. Before use, check to ensure the My First Forklift is in good condition. Check for damage to the battery, wires, and other parts of the forklift. - Page 17 CARE & MAINTENANCE 4. Keep the forklift away from furnaces, heaters, and direct sunlight. Plastic parts may melt. When charging, keep the forklift and battery away from ammable materials to prevent res. 5. Charge the battery immediately after use to maintain battery capacity. Charging should always be performed by an adult. Fully charge the battery before storing the forklift away for extended periods of time.
-
Page 18: Pre-Ride Checklist
PRE-RIDE CHECKLIST Ensure that your My First Forklift is in proper working order each time you ride. If a part of the My First Forklift does not function correctly, please contact our Customer Support Center. • Ensure the battery is fully charged before riding your My First Forklift. -
Page 19: Warnings
8. Replace the remote control batteries if the vehicle fails to operate at a distance of less than 9 feet between the operator and the vehicle. CAUTION: RIDING IN WET WEATHER Do not ride your My First Forklift in wet weather, as there are electronic components in the vehicle that may be damaged if exposed to water or moisture. -
Page 20: Saftey Precautions
Inspect the entire forklift thoroughly before every ride, and do not ride it until any problems have been corrected. WARNING Do not ride a My First Forklift with a part that is damaged. Replace the damaged part before riding. - Page 21 2. Due to the nature of the product, the assembly pieces should be checked before every ride to avoid an accident while riding. 3. Do not make sharp turns, as you may drift and overturn the My First Forklift, which can result in injury to yourself and/or damage the unit.
-
Page 22: Fcc Statement
FCC STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Please note that changes or modi cations not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. -
Page 23: Warranty
WARRANTY For warranty information, please visit us at www.hover-1.com Manufacturer: DGL Group, Ltd. 2045 Lincoln Highway, Edison NJ 08817 TEL: 732-692-5000... - Page 24 @Hover1Rideables @RideHover1 @RideHover1 www.hover-1.com...
Need help?
Do you have a question about the MY FIRST FORKLIFT and is the answer not in the manual?
Questions and answers