Page 5
MY FIRST FORKLIFT Operation Manual H1-FLFT l H1 FLFT IMPORTANT: KEEP FOR FUTURE REFERENCE *Images used in this manual may vary slightly from the product and are for reference purposes only. It is important for you and every rider to read...
Page 6
WARNING HELMETS SAVE LIVES! Always wear a properly fitted helmet that complies with CPSC or CE safety standards when you ride your vechicle. Inc o rre c t Fitting : C o rre c t Fitting : Fo re he a d is e xp o se d a nd Ma ke sure yo ur he lme t vulne ra b le to se rio us injury.
INTRODUCTION This manual is designed to give you the information you need for the safe operation and maintenance of your new Hover-1 My First Forklift. Please read it thoroughly before riding your Hover-1 My First Forklift. TABLE OF CONTENTS PAGES...
HOVER-1 MY FIRST FORKLIFT DIAGRAM 1. Front Fork 2. Fork Frame 3. Front Fork Link 4. Front Fork Lifting 5. Lever 6. Headlights 7. Roof 8. Chair 9. Support Frame 10. Trunk Lid 11. Door 12. Rear Wheel 13. Steering Wheel 14.
(2) Front Wheels Drive Gear (4) Wheel Cover (2) Rear Wheels (1) Support Frame (1) Charging Cable (Optional) (1) Lower Frame Assembly (1) Remote Control (Optional) (1) Steering Wheel (2) Levers to request missing www.hover-1.com Please visit or defective parts...
Page 10
PARTS LIST (1) Body (1) Front Fork Lifter (1) Roof (1) Fork Frame (1) Trunk (1) Toy Pallet (1) Trunk (1) Seat (2) Front Forks to request missing Please visit www.hover-1.com or defective parts...
Page 11
CARE & MAINTENANCE ASSEMBLING YOUR HOVER-1 MY FIRST FORKLIFT...
Page 12
ASSEMBLING YOUR HOVER-1 MY FIRST FORKLIFT...
Page 13
CARE & MAINTENANCE ASSEMBLING YOUR HOVER-1 MY FIRST FORKLIFT...
Page 14
CARE & MAINTENANCE ASSEMBLING YOUR HOVER-1 MY FIRST FORKLIFT...
Page 15
CARE & MAINTENANCE ASSEMBLING YOUR HOVER-1 MY FIRST FORKLIFT...
Page 16
CARE & MAINTENANCE ASSEMBLING YOUR HOVER-1 MY FIRST FORKLIFT...
Page 17
CARE & MAINTENANCE ASSEMBLING YOUR HOVER-1 MY FIRST FORKLIFT...
Page 18
STEERING WHEEL & REMOTE CONTROL PAIR REMOTE TO FORKLIFT If the remote is not pairing to the forklift, follow these instructions 1. Turn off the Forklift and remove the batteries from the remote. Put batteries back into the remote. 2. Press and hold the code button on the remote while turning on the forklift. 3.
Page 19
RIDING YOUR HOVER-1 MY FIRST FORKLIFT Ensure your Hover-1 My First Forklift is fully assembled and correctly installed with screws secured tightly in place. Failure to do so may result in serious bodily harm/death and damage to the vehicle. After reviewing the pre-ride checklist, follow the steps below to begin riding your Hover-1 My First Forklift.
Page 20
CARE & MAINTENANCE • Only use the charger and battery specified by the manufacturer. • Before charging,check the charger, battery and plug for any damage. If anything is damaged, stop using the vehicle until it is repaired. • Do not turn the vehicle on while charging and don’t turn the battery upside down •...
Page 21
CARE & MAINTENANCE CONTINUED 5 Vehicles should be kept away from direct heat, such as furnaces and heaters. Plastic parts may melt. When charging, keep away from flammable materials to prevent fire. 6. Charge the battery immediately after use. The charging must be done by adults. Fully charge the battery before storing away for extended periods of time.
Page 22
PRE-RIDE HOVER-1 MY FIRST FORKLIFT CHECKLIST Ensure that your Hover-1 My First Forklift is in proper working order each and every time you ride. If a part of the Hover-1 My First Forklift does not function correctly, please contact our Customer Support Center.
Page 23
8. Replace the remote control batteries if vehicle fails to operate at a distance of less than 9 feet between operator and vehicle. CAUTION: RIDING IN WET WEATHER Do not ride your Hover-1 My First Forklift in wet weather, as there are electronic components in your vehicle that may be damaged if exposed to water or moisture.
Inspect the entire forklift thoroughly before every ride, and do not ride it until any problems have been corrected. WARNING Do not ride a Hover-1 My First Forklift with a part that is damaged; replace the damaged part before riding.
Page 25
2. Due to the particularity of the product, the assembly pieces are to be checked before every ride to avoid an accident while riding. 3. Do not make sharp turns as you may drift and overturn the Hover-1 My First Forklift which can result in injury to yourself and/or damage the unit.
Page 26
FC C ST AT EMENT This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
WARRANTY For warranty information, Please visit us at: www.hover-1.com Replacement parts may be available for purchase at www.hover-1.com. Parts availability is not guaranteed. Manufacturer: DGL Group, Ltd. 195 Raritan Center Parkway Edison, NJ 08837 WARNING WARNING Read The Information Wear Personal...
Need help?
Do you have a question about the H1-FLFT and is the answer not in the manual?
Questions and answers