Advertisement
5C. Installation Instructions For
Shorty Style Helmets
J&M BT-05 Series Helmet Headset Installation Instructions
WARNING! Helmet speakers may not be legal in all jurisdictions. Check your local laws BEFORE using this product. J & M Corporation cannot control the circumstances surrounding the sale of this equipment, the
quality of installation, or the specific helmet into which this equipment is installed. Accordingly, J & M Corporation makes no warranties, expressed or implied, related thereto. A helmet with this equipment installed
may not protect the user from injury. The user assumes all liability in conjunction with accidents, injuries or losses of any kind arising out of the use of this product. Additionally, this product should not be used in
any way that would impair the user's ability to hear traffic or other noises. Accordingly, the volume should be kept low or off, depending upon the circumstances.
1
Figure
3
Figure
Installation into Shorty Style Helmets
1. Install the headset by first inserting the small center tab on the headset
into the back of your helmet between the interior and outer shell of your
helmet. See Figure 1.
2. Insert the large tab on the left side of the headset into your helmet in
the same manner making sure that the headset tab is on the inside of
the retention strap on your helmet. See Figure 2.
3. Repeat this procedure for the right side.
4. Reposition both sides of the headset as necessary so that both speak-
ers are correctly positioned over your ears.
4
Figure
5. Slide the clamp into the proper position on the left bottom edge of the
6. Complete the installation by plugging the headset into the BT-05 mod-
2
Figure
5
Figure
helmet shell, peel the backing off the double-sided tape, press the
clamp mounting base into place, then Install the Bluetooth module on
to the mounting-plate. See Figures 3, 4 & 5.
ule and then routing both helmet straps through the small retention
loops on both sides of the headset. See Figure 4.
Advertisement
