Table of Contents
Advertisement
Problem
The spin phase does not
operate or the washing cy-
cle lasts longer than usual-
ly.
There is water on the floor.
You cannot open the appli-
ance door.
The appliance makes an
unusual noise.
The cycle is shorter than
the time displayed.
The cycle is longer than
the time displayed.
The washing results are
not satisfactory.
You cannot set an option.
After the check, activate the appliance. The programme continues from the point of interruption.
If the problem occurs again, contact the Authorised Service Centre.
If the display shows other alarm codes. Deactivate and activate the appliance. If the problem continues,
contact the Authorised Service Centre.
TECHNICAL DATA
Dimension
Electrical connection
•
Set the spin option.
•
Set the drain option if you set an option which ends with water in
the drum.
•
Make sure that the drain filter is not clogged. Clean the filter, if nec-
essary. Refer to "Care and cleaning".
•
Adjust manually the items in the tub and start the spin phase again.
This problem may be caused by balance problems.
•
Make sure that the couplings of the water hoses are tight and there
is not water leakages.
•
Make sure that the drain hose have no damages.
•
Make sure you use the correct detergent and the correct quantity of
it.
•
Make sure that the washing programme is finished.
•
Set the drain or the spin programme if there is water in the drum.
•
Make sure the levelling of the appliance is correct. Refer to "Instal-
lation".
•
Make sure that the packaging and/or the transit bolts are removed.
Refer to "Installation".
•
Add more laundry in the drum. The load may be too small.
•
The appliance calculates a new time according to the laundry load.
See the "Auto sense function" at daily use chapter.
•
An unbalanced laundry load increases the duration time. This is a
normal behaviour of the appliance.
•
Increase the detergent quantity or use a different detergent.
•
Use special products to remove the stubborn stains before you
wash the laundry.
•
Make sure that you set the correct temperature.
•
Decrease the laundry load.
•
Make sure that you press only the wanted button(s).
Width/ Height/ Depth/ To-
tal depth
Voltage
Overall power
Fuse
Frequency
Possible solution
596 mm/ 854 mm/ 607 mm/ 643 mm
220-230 V
1850 W
10 A
50 Hz
19
Advertisement
Table of Contents
