Door Swing - GE UCC15NPRII Owner's Manual And Installation Instructions

DOOR SWING

Moving the hinges allows the door to open from either
the left or the right side. Change the swing BEFORE
attaching the door panel.
1. Remove the top and bottom hinge screw covers to
gain access to the screws.
2. Remove the hinge screws (4 total for top and
bottom hinge).
Remove
3. Remove the door.
4. Remove the door gasket and ice scoop .
the lower decorative cover at the 4 location shown
in the figure.
1
49-1000640 Rev. 3
Installation Instructions
Push to Release
2 3
6. Remove the upper decorative cover in the same way.
7. Remove the top hinge and hinge cover. Remove
the hinge cover from the hinge.
8. Remove the lower hinge and hinge cover. Remove
the hinge cover from the hinge.
9. Slide the original top hinge cover on the original
lower hinge and attach this assembly to the top, on
the opposite side of the original location.
10. Slide the original lower hinge cover on the original
top hinge and attach this assembly to the lower hinge
location, on the opposite side for the original location.
4
Steps 8-11
13