Door Swing; Installing The Ice Machine - GE UCC15NJ-II Owner's Manual And Installation Instructions

INSTALLING THE ICE MACHINE (Cont.)

DOOR SWING

The door can be attached to open with hinges on the left or
right using new brackets shipped loose in the ice bin. Retain
all screws for reuse.
To change:
1. Open the door. Remove 4 stainless steel screws opposite the
hinge side on the front of the cabinet.
2. Remove innermost screw holding each hinge to cabinet.
Loosen the other screw.
Remove
Upper Hinge Bracket
3. Slide the door to the side so the keyhole on the hinge clears
the screw and remove from cabinet.
4. Remove the screws that were loosened and save. Install
the 4 stainless steel screws that were removed in Step 1
into the open holes on the cabinet left by removing the
hinge.
5. Remove the door gasket.
6. Remove the hole plugs from the hole covers (if
applicable); a box cutter blade can be used.
Hole plug
Gasket
Cover
7. Remove screw holding hole cover to door and take hole
cover off (if applicable).
8. Remove screws holding door panel to door, and
separate the panel from the door.
9. Install the 2 hinge screws removed after the door was
removed from the cabinet into the outermost holes on the
new hinge side of the cabinet. Screw these in only about half
way.
10. Remove the upper hinge and move it to the door's
opposite side, bottom location. Secure using the original
screws.
12
Installation Instructions
Top Panel
Loosen
11. Remove the original lower hinge and move it to the
door's opposite side, upper location. Secure using the
original screws.
IMPORTANT: If installing a stainless steel door panel or custome
panel, skip to INSTALLING THE DOOR PANEL section.
12. Return door panel to its original position and secure
with the original screws.
13. Reinstall the hole covers and hole plugs.
14. Install the keyhole slot on the hinge over the outermost
screw, top and bottom, and slide the door onto the cabinet.
15. Attach the door to the cabinet using the original screws.
Tighten all 4 screws.
IMPORTANT: In some situations the door can open too far
and damage adjacent cabinets. To prevent this, insert a
Stop Pin (in hardware packet) into the provided hole in the
top and bottom hinges. Drive the pin into the hole until the
head is flush with the hinge.
Door stop pin
16. Slide the hinge covers from the hardware packet over
each hinge.
Side
Cover
Hinge Cover
17. Attach the side covers from the hardware packet over
the hinge by peeling off the covering over the adhesive
and placing it over the side of the hinge.
Note: If the unit is being built-in a screw can be used to
secure the unit to the cabinet in place of installing the
side covers.
18. Return the kickplate and front service panel to their
original positions and attach to the cabinet using the
original screws.