Advertisement
Quick Setup for the 841-t6
Table 3
defines the multifunction status LED state when running PlumeOS.
Color
LED State
Blue
Green
Green
Blinking (double)
N/A
N/A
White
Pulsing after 3 minutes
N/A
Green
Red
Rapid Blinking
Back Panel Status LEDs
There are four LEDs located on the back panel of the 841-t6 as shown in
2.4GHz / 5GHz Status LEDs
The 2.4GHz and 5GHz (1 & 2) status LEDs indicate the state of the wireless connections on the gateway.
LED
Color
Green
2.4GHz / 5GHz-1 /
5GHz-2
None
WPS Status LED
The WPS status LED indicates the status of WPS (Wi-Fi protected setup).
LED
Color
Green
WPS
None
Quick Setup for the 841-t6
The SDG product line can ship with two possible firmware options: PlumeOS and SmartOS. Quick setup instructions of WiFi and connection to
the Internet for your 841-t6 will vary based on which OS is installed on the device. Confirm whether your 841-t6 is deployed with SmartOS
firmware or PlumeOS firmware, then choose accordingly from the following options.
■ For devices shipped with PlumeOS installed, the setup requires installation of the HomePass smartphone app by Plume.
4
Table 3: Multifunction Status LED for PlumeOS
Event
Solid
Power On
Pulsing
Attempting to Connect
During device naming (this device) and waiting for optimization to finish
Off
During device naming (other devices)
Off
Internet working
Internet down (with power) or Internet still connected but lost cloud con-
nection.
Off
Cloud planned outage
Pulsing
Claimed device (by another account)
TFTP/recovery blink
Table 4: 2.4GHz and 5GHz Status LEDs
State
Description
On
Wi-Fi radio is UP.
Flashing
Wi-Fi radio is transferring data.
Off
Wi-Fi connection is DOWN.
Table 5: WPS Status LED
State
Description
On
WPS is enabled.
Flashing
WPS is passing traffic.
Off
WPS is not active.
Figure
2.
Figure 2. Status LEDs
841-t6 Mesh AP QSG
6SDG841T6-13A
Advertisement
