Step 5 Proceed Through The Screen Setup Menu - Hisense Laser Cinema PL1H Series Quick Setup Manual

STEP 5 Proceed through the Screen Setup
Menu
PROJECTION MODE
If you need to flip the image over top-to-bottom and/or left-to-
right, select the Projection Mode.
AUTO GEOMETRIC CORRECTION
Before you use Auto Geometric Correction function, ensure that
the Laser Cinema and your mobile device are connected to the
same wireless network.
1. Adjust the Laser Cinema position by using the levelling feet
as needed, ensure the frame of the screen is located inside
the rectangular border.
2. Click Next to continue.
3. Scan the QR Code with your mobile device to begin
Automatic Geometric Correction. After a few moments, an
alignment grid pattern will appear on the screen.
4. Click "+" on your mobile device to take a photo of the full
screen. For best results, stand about 10 feet away from the
screen and use landscape mode.
5. Click "upload" on your mobile device to complete the
Automatic Geometric Correction.
NOTE:
• Please ensure you are standing in front of the screen to
take the photo, no deviation of more than 25° from the
centre of the screen.
• Please ensure the whole screen is fully visible on the photo,
including the frame of the display.
• Please ensure all the 16 points of the grid on the screen are
all in focus when taking the photo.
• Please ensure the screen image must take up at least 60%
of the overall photo size for correct geometric correction.
14
Alignment grid