Hisense Laser Cinema PL1H Series Quick Setup Manual page 21

1. Slide the back cover to open the battery
compartment of the remote control.
2. Insert two AA or AAA size batteries.
Make sure to match the (+) and ( - ) ends
of the batteries with the (+) and ( - ) ends
indicated in the battery compartment.
3. Close the battery compartment with the
cover.
IMPORTANT INFORMATION ABOUT THE REMOTE AND
BATTERIES
• Discard batteries in a designated disposal area. Do not
throw them into a fire.
• Remove old batteries immediately to prevent them from
leaking into the battery compartment.
• If you do not intend to use the remote control for a long time,
then remove the batteries.
• Battery chemicals can cause a rash. If the batteries leak,
clean the battery compartment with a cloth. If chemicals
touch your skin then wash it immediately.
• Do not mix old and new batteries.
• Do not mix alkaline, standard (carbon-zinc) or rechargeable
(NiCd, NiMH, etc.) batteries.
• Do not continue using the remote if it gets warm or hot.
• Call our Support Center immediately on the support website.
REMOTE CONTROL RANGE INFORMATION
• The remote control can work at a distance of up to 8 metres
in front of the Laser Cinema. (This distance is used by
infrared means in an unpaired state.)
• The remote control angle: taking the remote sensor as an
apex, 6 metres away, its controlled horizontal angle is within
±30°, while the vertical angle is within ±15°. (This angle is
used by infrared means in an unpaired state.)
PAIRING THE REMOTE CONTROL (ONLY FOR BLUETOOTH
REMOTE CONTROL)
Pair the remote to the Laser Cinema after you power it on.
Keep the remote control within 3 metres from the Laser
Cinema. Press any button (except power and mic button) to
pair.
NOTE:
• In special cases, press and hold [
• If an unknown error occurred with the remote, then it could
have been caused by interference. Try to remove what's
causing the interference and pair it again.
• If an unknown error occurred in the remote control while
the battery power is normal, you can take out the batteries,
press any key for 1~2 seconds, and insert them back. Then
the remote control will work normally.
• The remote cannot be paired to the Laser Cinema while the
Laser Cinema is in standby mode.
13
] button to pair.