Table of Contents
Advertisement
with salt whenever salt warning indicator
appears on the display of your machine.
Adjusting the water hardness level is
explained in Water Softening System
section.
Rinse Aid indicator ( )
Please check the rinse aid indicator on the
display to see whether there is adequate
amount of rinse aid in the dishwasher or
not. You need to refill the rinse aid reservoir
with rinse aid whenever rinse aid warning
indicator appears on the display of your
machine.
Adjusting the amount of rinse aid
1. After turning on the machine, press Time
Delay and P+/P keys simultaneously.
Keep them pressed until the countdown
3, 2, 1 is completed on the display.
2. Press P+/P to move to position P on the
display.
3. Set to the appropriate level with the Time
Delay key.
4. Press On / Off key to save the setting.
No rinse aid dispensed in P:0 wash position.
1 dose of rinse aid is dispensed in P:1
position.
2 doses of rinse aid are dispensed in P:2
position.
3 doses of rinse aid are dispensed in P:3
position.
4 doses of rinse aid are dispensed in P:4
position.
End of programme
End of Programme indicator will light up
once the washing programme is over.
1. Press the On/Off button to turn off your
machine.
2. Close the tap.
3. Unplug the machine from the socket.
36/EN
For energy saving, the product is
automatically turned off following the
completion of the programme or if the
programme is not started.
Leave your dishes in the machine for
about 15 minutes to cool down after
they are washed. Your dishes will dry
in a shorter time if you leave the door
of your machine ajar during this period.
This process will increase the drying
effectiveness of your machine.
Water cut-off warning
If mains water is cut or water inlet tap is
turned off the machine cannot take water in
and E:02 icon will flash on the programme
indicator. As long as the problem continues,
washing programme is paused and the
water inlet is checked regularly by the
machine; when the water is restored E:02
icon will disappear after a while and the
washing programme resumes.
Overflowing warning
If the machine intakes too much water or
there is leakage at any of the components
then the machine will detect this and E:01
icon will flash on the Programme indicator.
As long as the overflowing continues safety
algorithm will be active and try to discharge
the water. If overflowing stops and safety
is assured, E:01 icon will disappear. If E:01
does not disappear, there is a permanent
fault. In this case the authorised service
should be contacted.
Advertisement
Table of Contents
