Table of Contents
Advertisement
Quick Links
Parts Included:
(1) Roll Tray with Slides Attached
(1) Pair of Cabinet Member Slides
(2) Mounting Back Sockets
(2) 1/8" Snap-on Spacers
(6) #6 x 5/8" Wood Screws
(2) #6 x 1" Wood Screws
(1) RTBP Kit (Includes bumpers & #6 screws)
STEP 1
(10/15/21)
Instructions for Roll Tray Kit
Remove the doors from the cabinet. Attach mounting back sockets to cabinet slides by sliding back
socket over back of slide.
Mounting back socket to be installed with dowel facing towards inside of cabinet.
Mounting back socket to be installed with dowel facing towards outside of cabinet.
Make sure the slide is oriented as shown in detail below and snap 1/8" thick roll tray spacer onto
cabinet member.
Repeat step for opposite cabinet member slide.
Tools Needed:
Phillips Head Screwdriver
Tape Measure
Drill
7/64" Drill Bit
Level
Marking Tool
SKU's Affected:
RT18
RT24
A5176 R0
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for LOWES RT18
Summary of Contents for LOWES RT18
- Page 1 Instructions for Roll Tray Kit Parts Included: SKU’s Affected: Tools Needed: (1) Roll Tray with Slides Attached Phillips Head Screwdriver RT18 (1) Pair of Cabinet Member Slides Tape Measure RT24 (2) Mounting Back Sockets Drill (2) 1/8” Snap-on Spacers 7/64” Drill Bit Level (6) #6 x 5/8”...
- Page 2 STEP 2 Place slides in cabinet in desired location. Installation at Bottom of Cabinet Place slide assembly with mounting back socket in corner of cabinet where back panel/end panel/bottom meet. Attach mounting back socket to back panel using (3) #6 x 5/8”...
- Page 3 STEP 4 Installation of Roll Tray Bumper Protector Kit Place the bumper directly on top of the roll tray guide and along the edge of the roll tray front. Fasten the bumper to the roll tray with the #6 x ½” screw provided. Slide the roll tray into the cabinet members located on the slide rail assemblies.
Need help?
Do you have a question about the RT18 and is the answer not in the manual?
Questions and answers