Advertisement
IDSCAN use two area to operate:
WORKING AREA
is the scan operation area.
SETTINGS AREA
is an area where to set some useful parameters.
TURN ON/OFF
TURN-ON Press for a short time the key
TURN-OFF Press the key
WORKING AREA
After turn on the LCD display the current version.
If IDSCAN remains inactive for more than 3 minutes automatically will be turn off to preserve the battery.
LOW BATTERY
If a low battery is detected appears:
The LCD lamp and BUZZER flash three times and IDSCAN turn-off.
If no alarm detected appears :
BATT: show the battery level %.
RFID SCANNER
To start the tag detection press
IDSCAN attempt to recognize an unknown transponder.
Before it run a scan on LF frequency
and next a scan on HF
and next a scan on UHF
When a TAG is detected the LCD lamp and BUZZER flashes 3 times.
On the LCD appear the Tag Type and the UID detected.
The UID length and meaning is different for any Type of Tag.
Refer to the "Technical Specification" of that TAG.
If no detection:
PAGE READ
Place the TAG in the RF field.
To read the UID press
To read the PAGES on the tag use
the PAGE number and press
Will appear the read value in HEX format.
If a Data Error was detected appear Read Error.
To repeat press
OPERATION MODE
for about 2 sec.
.
.
to increment or decrement
.
IDSCAN 5.0
Low Battery
Scanner Ready
BATT:
- - - -
Running LF
Running HF
Running UHF
HITAG-1
UID
TAG UNKNOWN
HITAGS
UID
34C456F8
HITAGS
004
12345678
HITAGS
004
Read Error
2
Advertisement
