TMG -HW41T Product Manual page 13

2.Attach high-pressure hose to hot water outlet quick connector. Attach the other end of high pressure
hose (with quick coupler) to spray gun. Ensure that quick disconnect connections are tightly locked
together. Apply a sharp pull on hose to confirm they are secured.
Attach wand nozzle specific to task requirements (i.e. chemical or pressure wash).
[Quick Coupling Operation – Pull back sleeve end and insert male end into nozzle quick coupler,
release sleeve and confirm connection by pulling on the nozzle].
3.Attach water source to water inlet located on pump. The water source must be attached with a good
quality standard garden type hose (1/2" minimum is required). Connect quick connector of the hose into
pump outlet fitting. Make sure that the inlet screen/filter is intact and fitted correctly. Turn on water source.
WATER MUST BE IN SUFFICIENT SUPPLY, AND PRESSURE MUST BE BETWEEN 20 –60 PSI TO
ENSURE PROPER AND SAFE OPERATION. Specific attention should be given if using a well water
supply. Ensure water is flowing from end nozzle with the trigger gun pulled. Deplete system of all air.
4.Start Gas Engine
Refer to instructions in engine manual. MAKE SURE THAT THE ENGINE EXHAUST IS NOT FACING ANY
FLAMMABLE MATERIALS.
WW W . T M G I ND U S T R I A L . C O M P1 3 / 4 1 T ol l Fr e e : 1 - 8 7 7 - 7 6 1 - 2 8 1 9