Advertisement
PROGRAMMING THE REMOTE
In order to program the Universal Remote, the LEARN button on the
garage door opener must be located. Please refere to page 3 as well as
the compatibility table on page 2 for the lean button label used for various
brands.
These are generic instructions for most garage door openers, for
ATA branded openers refer to the instructions on page 5. Read through
all steps before commencing, and become familiar with the control buttons.
Once the programming sequence has commenced its important to
continue from one step to another reasonably quickly. Time between
steps is critical.
This is also a good time to view our Instructional videos on our website.
chamberlaindiy.com.au/universal or chamberlaindiy.co.nz/universal.
1
Start with your garage door closed. Ensure that the door is clear of all
obstructions.
2
Press and hold the Bottom Button (for
approximately 15 seconds) on the
remote control until the blue LED stays ON
solid, then release the button. (The blue
LED will remain ON for 60 seconds).
3
Press the LEARN button on your garage door opener for 2-3 seconds,
then release it.
4
Immediately Press & Release the remote control button you would like
to program. The Blue LED will commence blinking for 12 seconds.
Once the Blue LED changes to solid, immediately Press & Release
the same button on the remote again. The remote will now try to pair
to the opener.
5
The Blue LED on the remote control will begin to flash once every three
seconds while trying to pair to the opener, (this may take up to 60
seconds). When the door begins moving, immediately (within 3
seconds) press the remote button again.
6
The coding process is complete and your remote should now be
programmed to the garage door opener.You can repeat this process
using the other remote button to program another garage door opener.
TEST
Test the remote control by pressing the button you programmed to control
the door. If the garage door opener does not activate, repeat the
programming steps, view the programming videos on
chamberlaindiy.com.au/universal or chamberlaindiy.co.nz/universal or
contact Customer Service AU: 1800 638 234 NZ: 0800 653 667
Blue LED
Bottom
Button
4
Advertisement
