Subaru Outback 2015 Manual page 190

! Screen Settings
After entering the "Screen Settings" menu,
select one of the following menus.
! Welcome Screen
The welcome screen can be activated or
deactivated. Select "On (with Sound)" to
activate the screen and sound. Select "On
(without Sound)" to activate the screen
and deactivate the sound. Select "Off" to
deactivate the screen.
! Good-bye Screen
The Good-bye screen can be activated or
deactivated. Select "On" to activate the
screen. Select "Off" to deactivate the
screen.
! Gauge Initial Movement
The movement of the meter needles and
gauge needles that occurs when the
ignition switch is turned to the "ON"
position can be activated or deactivated.
Select "On" to activate. Select "Off" to
deactivate.
! Gear Position Indicator Settings
(MT models)
The gear position indicator light can be
activated or deactivated. Select "On" to
activate. Select "Off" to deactivate.
! Units (U.K. models)
You can select the displayed units of the
distance, vehicle speed and volume.
Operate the " " or " " switch on the
steering wheel to display the preferred
units. Then pull the " /SET" switch to
select the displayed units.
! Languages
Operate the " " or " " switch on the
steering wheel to display the preferred
language. Then pull the " /SET" switch to
select the displayed language.
! Combination Meter Illumination (if
equipped)
After entering the "Combination Meter
Illumination" menu, select the following
menu.
! Meter Ring Illumination
The illumination of the combination meter
rings can be activated or deactivated.
Select "On" to activate the illumination.
Select "Off" to deactivate the illumination.
! SI-DRIVE Indication
You can activate or deactivate the indica-
tion of the SI-DRIVE mode. Select "On" to
activate the indication. Select "Off" to
deactivate the indication.
Instruments and controls/Multi information display
! Manual Mode Indication
You can activate or deactivate the gear
position indicator. Select "On" to activate
the indication. Select "Off" to deactivate
the indication.
! Illumination Color Selection
You can change the illumination color of
the combination meter. Select the pre-
ferred color (No. 1 to No. 10).
! EyeSight (models with EyeSight
system)
NOTE
For models with the EyeSight system,
refer to the Owner's Manual supple-
ment for the EyeSight system.
After entering the "EyeSight" menu, select
one of the following menus.
! Warning Volume
The volume of the warning buzzer that
sounds when the EyeSight system is in
use can be set in 3 stages ("Max", "Mid"
and "Min").
! Lead Vehicle Acquisition Sound
When adaptive cruise control is used, the
buzzer that sounds under any of the
following conditions can be activated or
deactivated.
. A vehicle is detected in front
3-45
– CONTINUED –