Maintenance And Safety Inspection - Hitachi EUP-B712 Instruction Manual

6. Maintenance and Safety Inspection

1) After using the probe, it should be cleaned and disinfected
or sterilized according to "4. Reprocessing Procedure", then
store it in a cool and dark place avoid high temperature and
humidity, direct sunlight.
2) After using the Magnetic sensor attachment and the Spacer for
EZU-RV2S, it should be cleaned, disinfected or sterilized according
to "4. Reprocessing Procedure", then store it in a cool and dark
place avoid high temperature and humidity, direct sunlight.
3) After using the Needle guide bracket, it should be cleaned and high
level disinfected according to "4. Reprocessing Procedure", then
store it in a cool and dark place avoid high temperature and humidity,
direct sunlight.
4) Visually inspect the surface of the probe head, housing, cable and
connector for any crack, scratch or denaturalization. If you find
any damage, do not use the probe and contact a service support
immediately.
5) Visually inspect the surface of the Magnetic sensor attachment and
the Spacer
denaturalization. If you find any damage, do not use it and contact
a service support immediately.
6) Visually inspect the surface of the Needle guide bracket for any
crack, deformation or denaturalization. If you find any damage, do
not use it and contact a service support immediately.
for EZU-RV2S for any crack,
-37-
deformation or
Q1E-EP1412