Advertisement
3. To install IDE hard disk on Model XM-EN3400-BK, connect the IDE and Power cable
as shown in Figure 3.
4.
To install SATA Hard disk on Model XM-EN3200-Bk (Shown in Figure 4) or XM-
EN3400-BK (Shown in Figure 4.1)
5.
After connecting the Hard disk, slide in the installed hard disk with panel back into
Enclosure, and use 4 provided screws to tighten the Hard Disk (Figure 5). Then insert
back both side plastic rail cover. Lastly, use the 2 screws to tighten the Enclosure
panel.
6.
After finish all hardware installation, you can connect the USB cable from the
Enclosure to the computer system.
3.5" USB2.0 HDD External Enclosure
Figure 3
Figure 4
Figure 4.1
Figure 5
Page | 5
Advertisement
