Connect Drain Hose - Airwell CDMX-022N-09M25 User & Installation Manual

CAUTION
When drilling the wall hole, make sure to
avoid wires, plumbing, and other sensitive
Outdoor
≈ 12mm / 0.5"
Step 4:

Connect drain hose

The drainpipe is used to drain water away from
the unit. Improper installation may cause unit
and property damage.
CAUTION
Insulate all piping to prevent condensation,
•
which could lead to water damage.
If the drainpipe is bent or installed
•
incorrectly, water may leak and cause a
water-level switch malfunction.
In HEAT mode, the outdoor unit will
•
discharge water. Ensure that the drain hose
is placed in an appropriate area to avoid
water damage and slippage.
DO NOT pull the drainpipe forcefully. This
•
could disconnect it.
NOTE ON PURCHASING PIPES
Installation requires a polyethylene tube
(exterior diameter = 2.5cm or 3.7-3.9cm)
(depending on models ), which can be
obtained at your localhardware store or
dealer.
 Page 26 
Wall
Indoor
Indoor Drainpipe Installation
Install the drainpipe as illustrated in the following
Figure.
(A)
Drain hose
Drainpipe Metal clamp
connecting port
(B)
Insulation
1-1.5m
(39-59")
Downward slope
1/100
1-1.5m
(39-59")
Downward slope
1/100
1-1.5m
(39-59")