Malfunction
Short buzzing sound
after switching on
of the device.
Loud noise during
spinning.
Clapping, clattering
in the pump.
Slurping, rhythmic
suction sound.
wrinkling.
Spin result is
not to satisfaction-
ness. The laundry is
too wet / too damp.
Cause and Troubleshooting
Intelligent dosing system performs a function test.
No error - normal operating noise.
▶
The appliance is not leveled properly.
→ "Adjusting the device", Page 17
▶
Device feet are not fixed.
Secure the device feet.
▶
→ "Adjusting the device", Page 17
Transport protections have not been removed.
→ "Remove transport locks", page 14 .
▶
A foreign object has entered the pump.
→
"Cleaning the drain pump", page 41
▶
Pump is active, the solution is being pumped out.
No error - normal operating noise.
▶
Spin speed is too high.
Set a lower spin speed for the next wash.
▶
The load quantity is too high.
Reduce the load during the next wash.
▶
Inappropriate program set for the type of fabric.
Select a suitable program for the type of fabric.
▶
Low spin speed is set.
Set a higher spin speed for the next wash.
▶
Start the programCentrifuge.
▶
Anti wrinkleis activated.
Select a suitable program for the type of fabric.
▶
Drain pipe or water drain hose is clogged.
Clean the drain pipe and the water drain hose.
▶
Drain pipe or water drain hose is kinked or
pinched.
Make sure that the drain pipe and the water
▶
drain hose are not kinked or pinched.
The unbalance detection system has interrupted the
spin cycle due to uneven distribution of the laundry.
Redistribute the laundry in the drum.
▶
TroubleshootingNL
53