Compass - Cobra XRS 9775 Operating Instructions Manual

Settings
Your Detector
Intro Operation Customer
Assistance
Select/Dim Button
Program/Mute Button
Secondary Icons
To set the IntelliMute Activation Point using Program Mode
(See page 7 for instructions on using Program Mode)
In Program mode, go to Set
IntelliMute.
Press and release the Set/City button Notice
to begin setting IntelliMute RPMs.
Rev your engine to the level you wish to
set. Rev the engine slightly above idle and
in Icons
hold revs steady for two seconds.
At the desired rev level, press and
release the Set/City button.
Press and release either the
Intro Operation Customer Warranty
Assistance
Select/Dim button to proceed to the
next user mode or the Program/Mute
button to exit the Program mode.
condary Icons
NOTE
If the unit is unable to sense usable pulses within three
seconds or if you do not set a rev point within 20 seconds
Notice
of beginning these steps, IntelliMute will indicate an error
and automatically turn off.
Tone Visual Display
One beep IntelliMute not set
Please try again
One beep IntelliMute Off
16 English
Warranty
Tone Visual Display Voice
None Set IntelliMute None
Two beeps Press SET Set Engine
at desired Revs
RPMs...
None None None
Three beeps IntelliMute IntelliMute
Set! Set
None None None
Setting IntelliMute RRMs
S e t I n t e l . . . PressSET...
IntelliMute
Not Set
Voice
I n t e l l i M u . . .
IntelliMute not set
Please try again
Please tr...
IntelliMute Off
Main Icons
Your Detector
Intro
Set/City

Compass

Button
Your detector includes an internal
Intro Operation
8-point Compass that will continuously
display your current direction of travel:
N, NE, E, SE, S, SW, W, or NW.
Secondary Icons
Secondary Icons
Calibrating the Compass
NOTE
Before using it for the first time, you must calibrate the compass to
Notice
provide accurate indications of direction. See page 7 for instructions
on using the Program mode to select Set Compass.
Calibration allows the compass electronics to measure and store
Main Icons
information about the magnetic fields generated by your vehicle.
The compass will remain accurately calibrated as long as your detector is
mounted in the same place in your vehicle. If you change the location where
the unit is mounted or move it to another vehicle, you must recalibrate the
Intro Operation
compass.
The compass temporarily may not provide accurate readings if you are inside
a building or enclosure, or are close to a large metal tractor/trailer, truck, or
train. Once you are away from such a location, the compass will work
Secondary Icons
correctly again.
I n t e l l i
NOTE
Mute
When the instructions direct you to drive in two circles, a large parking
Set!
Notice
lot is the most convenient place to do so. It does not matter what
direction your vehicle is pointing when you start the circles, which
IntelliMute Off direction you go to make the circles, and it does not have to be exactly
two circles. You do NOT have to make perfect circles. You can drive in
I n t e l l i
any pattern, as long as you make two complete turns. Four three-point
turns, two small squares, or any two complete loops will work as well as
Mute
two circles. It does not matter what size the circles are, if your speed is
Off
constant, or how fast you make the circles (but less than two minutes).
Please be careful when making the circles and watch for other traffic.
Settings
Operation Customer Warranty
Assistance
Customer Warranty
Assistance
W
Notice
Customer Warranty
Assistance
N
NW NE
8-Point
E
Compass
SW SE
S
Nothing comes close to a Cobra ® 17