Installation; Determine Installation Location On Pole; Install Ww200 System On Pole - Carmanah WW200 User Manual

4.0 Installation

For solar engine and LED load installation, please use the E/F Series user manual at
support.carmanah.com. This will also be included with your WW200 system.
The following is a summary of the installation sequence of the WW200:
1. Determine installation location on pole for the external radar and LED load
2. Install WW200 solar engine and LED load on pole per included E/F Series user manual
3. Drill holes for radar cable and bolts, if required
4. Fish radar cable, install radar & mount to pole
5. Aim radar module
6. Connect and configure radar module
7. Test system
4.1

Determine Installation Location on Pole

The radar module should be mounted on the pole so that its front face directly faces and has an unobstructed
view of oncoming wrong-way traffic. The radar module cable is 9.8 ft (3.0 m) long. To allow sufficient cable slack,
the vertical distance between the radar mount and the WW200 system should be at most 7 ft (2.1 m).
For optimal radar performance:
For maximum range, mount radar at least 6 ft (1.9 m) above the ground
•
Minimize the angle between target wrong-way traffic and the radar module
•
If the radar module can't be located near the side of the road, it may need to be pointed further up
the road to detect vehicles effectively.
4.2

Install WW200 System on Pole

Use the E/F Series user manual supplied with your system to install the WW200 system onto the pole.
Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 |
WW200 USER MANUAL
4.0 INSTALLATION
customersupport@carmanah.com |
8
carmanah.com