NOTE suggests optimal conditions and provides additional information. Warranty Disclaimer This manual will familiarize you with the features, operation standards and installation of Carmanah's WW200 Wrong-Way Vehicle Detection and Warning System. Failure to comply with the use, storage, maintenance, installation or placement instructions detailed in this manual could void the warranty.
WW200 USER MANUAL 1.0 WARNINGS AND PRECAUTIONS System Overview and Components The WW200 system actively monitors the roadway for wrong-way traffic. The system is comprised of the following components: • One self-contained solar engine comprising of the solar panel, batteries and control circuitry One or more R5-1a LED Enhanced Sign (red LED) •...
2.0 INTRODUCTION 2.0 Introduction The WW200 uses an external radar module to detect wrong-way events. Once a vehicle has been detected, it will activate the system’s LEDs to warn the driver of their error and encourage self-correction. Radar positioning, sensitivity, range and detection speed can be adjusted so only wrong-way events trigger the system. A WW200 can be paired with multiple WW200 or WW100 flashing warning signs if equipped with the wireless add-on.
WW200 USER MANUAL 2.0 INTRODUCTION Radar Module The WW200 system uses the Houston Radar DR600 radar. The radar detects wrong way vehicles and activates the system. The radar operates in the 24 - 24.25 GHz band and is configured using PC-based software.
WW200 USER MANUAL 3.0 OPERATION 3.0 Operation When the WW200 is triggered, it will flash for a pre-set field-adjustable duration (see Output Hold Time setting, Section 6.4). When installed with additional WW200 or WW100 systems with the wireless add-on, the WW200 can activate all systems’...
The radar module cable is 9.8 ft (3.0 m) long. To allow sufficient cable slack, the vertical distance between the radar mount and the WW200 system should be at most 7 ft (2.1 m). For optimal radar performance: For maximum range, mount radar at least 6 ft (1.9 m) above the ground...
Install the radar module with its cable facing down to optimize both detection range and resistance to water ingress. Pole mount through bolts shown not supplied. Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 | customersupport@carmanah.com carmanah.com...
Tilting the radar downwards will progressively decrease detection range. This can be useful to fine tune when wrong-way vehicles enter the detection zone. Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 | customersupport@carmanah.com carmanah.com...
4.0 INSTALLATION Connect and Configure Radar Module Plug the radar cable connector onto its mate on the radar PCBA within the WW200 system. Turn the barrel firmly clockwise to lock the connectors together. The radar module is configured from the factory to trigger an activation whenever an oncoming wrong-way vehicle is detected approaching at a speed of at least 5 mph (8 km/h).
WW200 USER MANUAL 4.0 INSTALLATION Test System Ensure that the WW200 system is connected and powered up. See the Carmanah E/F Series user manual at support.carmanah.com for details. Test that the system activates as wrong-way vehicles approach the desired trigger zone. If the LED loads fail to turn on, check the following: Nothing is obstructing the radar module’s view of oncoming wrong-way vehicles...
The system is designed to be maintenance free, but maximum system performance is achieved when the LED lenses and solar panels are clean. When inspecting the interior of the WW200 system, ensure that the vent screens are undamaged and that the vents are clear and allow airflow.
Adjusting settings not outlined in this section may adversely affect radar detection performance. Contact Carmanah for assistance with any configuration settings not discussed in this manual. Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 | customersupport@carmanah.com...
This is done by clicking the button from the Connection tab of the Connect to Radar window: After a few moments, the Radar Clock listed will match the computer’s clock. Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 | customersupport@carmanah.com...
Speed Limit: wrong-way vehicles travelling above or below this speed (depending on the “Trigger Event” setting) will trigger an activation of the connected WW200 system. Default setting is 5 mph. Maximum Detectable Speed: vehicles travelling above this speed will not trigger an activation of the connected WW200 system.
WW100 system(s) continue to flash after the radar module stops sensing wrong-way vehicle motion. Default is 10 seconds. Trigger Event: this setting changes the conditions under which an activation of the WW200 system is triggered: None: no activations will occur.
6.0 RADAR MODULE CONNECTION & SETTINGS Advanced Statistics (Optional) The WW200 can be optioned with the Advanced Statistics package. This allows for download and analysis of traffic data using the Houston Radar Advanced Stats Analyzer program (https://www.houston-radar.com). For full instructions please see the Advanced Stats Analyzer user manual.
Page 19
2. Create a new project on the left hand side and drag over the data into the project and then click Import. If you have successfully downloaded the data you can click on “Erase Radar Data” to start collecting new data. Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 | customersupport@carmanah.com carmanah.com...
Page 20
5. Click on all report checkboxes you wish to apply to the report. 6. Click on “Analysis Report.” If there are no vehicles detected/logged in the data you will be warned after clicking Analysis Report. Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 | customersupport@carmanah.com carmanah.com...
1. Radar module configured to detect outgoing vehicles: triggered by outgoing Ensure “Trigger Direction” setting on radar module is configured • wrong-way vehicles. correctly (see Section 6.4). Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 | customersupport@carmanah.com carmanah.com...
Page 22
Adjust WW200 flash pattern to have desired flash behavior using the manner. OBUI. See EMS Programming and Testing section of Carmanah E/F Series user manual. Carmanah Technologies Corp. | 250 Bay St, Victoria, BC V9A 3K5, Canada | 1.250.380.0052 | customersupport@carmanah.com carmanah.com...
Need help?
Do you have a question about the WW200 and is the answer not in the manual?
Questions and answers