Wireless > Advanced Settings; Switch; Switch > Port Management - Linksys WET200 User Manual

Chapter 
EAP-TLS
EAP-TLS uses a Certificate file for authentication. The Login
Name and Private Key Password are used to decrypt the
certificate file.
Encryption This is set to AES and cannot be changed.
Login Name Enter your login name for the RADIUS server.
Private Key Password Enter your password.
Certificate Enter the name of your certificate file or click
Browse to locate it. Click Import to load and decode the
certificate file. Click Apply to save the configuration for
wireless authentication while being associated with an
Access Point.
PEAP
EAP-PEAP uses the Login Name and Password to perform
authentication with the RADIUS server.
Encryption
This is set to AES and cannot be changed.
Login Name
Enter your login name for the RADIUS server.
Private Key Password
Enter your password.
When you are finished configuring the above settings,
click Apply to apply your changes, or click Cancel to
cancel your changes.
Wireless > Advanced Settings
This screen lets you configure advanced wireless settings.
Linksys recommends letting the Bridge automatically
adjust the parameters for maximum data throughput.
Wireless > Wireless Security - Advanced Settings
Transmission Rate The default setting is Auto. The range
is from 1 to 54 Mbps. The rate should be set depending on
the speed of your wireless network. You can select from a
range of speeds, or keep the default setting, Auto, to have
the Bridge automatically use the fastest possible data
rate and enable the Auto-Fallback feature. Auto-Fallback
negotiates the best possible connection speed between
the Bridge and another wireless-equipped device.
Wireless-G Business Ethernet Bridge
Advanced Configuration
RTS Threshold
This determines how large a packet can be
before the Bridge coordinates transmission and reception
to ensure efficient communication. It should remain at its
default setting of . If you encounter inconsistent data
flow, only minor modifications are recommended.
Fragmentation Threshold
packet before it is split to create a new packet. It should
remain at its default setting of . A smaller setting
means smaller packets, resulting in more packets per
transmission. If you experience high packet error rates,
you can decrease this value, but it will likely decrease
overall network performance. Only minor modifications
of this value are recommended.
Cloning Mode
You can clone the MAC address of any
network device onto the Bridge. To disable MAC address
cloning, keep the default setting, Disable. To use the MAC
cloning feature, select Enable.
If you have enabled MAC cloning, then select Auto if you
want to clone the MAC address of the device currently
connected to one of the LAN ports. The Bridge will actively
scan for a new MAC address to be cloned whenever you
disconnect and reconnect the Bridge through a LAN port.
Select Manual if you want to specify a MAC address in the
Enter MAC Address field. This is useful when the Bridge is
connected to multiple devices through a switch or a hub.
Click Apply to apply your changes, or click Cancel to
cancel your changes.

Switch

The Switch tab contains seven screens that allow you to
configure the advanced Ethernet switch features. The
managed switch has five 10/100 Ethernet ports which
allow advanced VLAN and QoS settings.
Switch > Port Management
The Port Management screen allows you to configure
and set the status of each of the Bridge's ports—the five
Ethernet ports and the wireless "virtual" interface.
Switch > Port Management
The maximum size of a data