Intellimute Pro; Voice/Tone Setting; And Spectre I & Iv+ Alert Settings - Cobra XRS 9445 Operating Instructions Manual

Settings
Your Detector
Intro Operation Customer Warranty

IntelliMute Pro

Assistance
IntelliMute Pro prevents detection by radar detector detectors (RDDs) such as
VG-2, Spectre I and Spectre IV+ when traveling at slower speeds. It is intended
for use by experienced users only.
Operation Secondary Icons Customer Warranty
When IntelliMute Pro is turned On, and engine RPMs are below the IntelliMute
Assistance
activation point, your detector's radar detection circuits are turned Off to
prevent detection by RDDs.
Customer Before IntelliMute Pro can be turned On, you must have turned On and Set the
Installation
Assistance
IntelliMute activation point. (See pages 9 through 11.)
Notice
CAUTION
When IntelliMute Pro is On, NO radar signals will be detected and
NO alerts will be given at RPMs below the IntelliMute activation point.
Notice Caution Warning
To Turn IntelliMute Pro On
While no signal
Tone Voice
is being detected,
Two beeps IntelliMute Pro On
press and hold both
the IntelliMute
and City buttons
for four seconds.
To Turn IntelliMute Pro Off
Press and hold both Tone Voice
the IntelliMute and
One beep IntelliMute Pro Off
City buttons for
four seconds.
12 English
Your Detector
Intro

Voice/Tone Setting

You can set your detector to sound alerts with either a Voice or a Tone. You can
change settings by using the Mute button. In Voice Alert mode, you will first hear
several tones, then a voice message announcing the type of signal detected, followed
Secondary Icons
by more tones. In Tone Alert mode, you will hear the tones only. The factory setting
is Voice Alert mode.
To Change From Voice Alert to Tone Alert
While no signal
is being detected,
press and hold
the Mute button
for two seconds.
To Change From Tone Alert Back to Voice Alert
While no signal
IntelliMute Button
is being detected,
City Button
press and hold the
Press and hold both
Mute button for
buttons simultaneously
two seconds again.
IntelliMute Pro On
VG-2 and Spectre I & IV+ Alert Settings
c
X K Ka V S
Police use radar detector detectors (RDDs) to spot users of radar detectors.
Your detector is able to identify signals from VG-2, Spectre I and Spectre IV+
RDDs and can provide alerts when any of these or similar devices are in use
Visual Display near your vehicle.
c or h will blink
Your detector can be spotted by Spectre IV+ RDDs, but is invisible to VG-2 and
Spectre I RDDs. You can choose whether you want to be alerted to VG-2 and
Spectre I & IV+ RDD signals. The factory setting for VG-2 and Spectre I & IV+
alerts is Off.
To Turn VG-2 and Spectre I & IV+ Alerts On and Off
Visual Display While no signal
is being detected,
c or h will show
press and hold the
steady
Dim button for
four seconds.
Settings
Operation Customer Warranty
Assistance
Tone Voice Visual Display
Notice
One beep Tone Alert None
Tone Voice Visual Display
None Voice Alert None
Tone Voice Visual Display
On = Two Beeps Spectre VG-2 On V will blink twice
in the display
Off = One Beep
Spectre VG-2 Off V will blink once
in the display
Nothing Comes Close to a Cobra ® 13