Table of Contents
Advertisement
Installation, Operation and Maintenance Manual
MAN-02-10-92-0705-EN Rev. 0
Section 2: Lubrication
2.1
Lubrication Grease Specification
Extreme pressure multipurpose grease, NLGI Grade EP-0, suitable for bronze
gear assemblies.
Inspection Procedure:
1. Ensure the worm is immersed in lubricant. Lubrication should be checked periodically
to determine its condition.
2. Examine the lubricant for containments such as dirt or water. Should contamination
be present, remove the grease and flush with a commercial degreaser, solvant such
as mineral spirits (or white spirits), which is non-corrosive and does not affect seal
materials. Refill with fresh lubricant.
3. Examine the lubricant for consistency. The appearance should be slightly fluid.
NOTE:
Alternate lubricants may be substituted in place of the standard that is supplied by the
factory only if they are equivalent. Do not add different lubricants to the operator unless
approval has been obtained from the lubricant manufacturer.
Installation Procedure
Section 2: Installation Procedure
March 2019
2
Advertisement
Table of Contents
