Katadyn Steripen UltraLight - Water Purifierm Quick Start Guide

How to use

1. The UltraLight's USB-rechargeability offers a variety of recharging choices. Charge using a solar panel, wall plug in, or your computer.
   
2. 
   
3. Place lamp in clear water and completely submerge the metal water sensor pins. The ultraviolet lamp will turn on and the green LED indicator light will start to flash after the UltraLight has been submerged for about 2 seconds.
   
   
4. The green LED light will flash for the entire treatment. Gently stir the water with the steripen to ensure uniform purification. When the green LED light turns solid and the UV lamp turns off, the treatment is complete.
   

LED Indicator

SUCCESSFUL

	Treatment in progress
	Successful Water Treatment
	Batteries are low, please recharge
	UV lamp is good for less than 100 uses

UNSUCCESSFUL

	Recharge batteries
	Lost water detection
	Lamp is damaged or has expired

Anatomy Composition

1. Lamp cover
2. UV lamp Lampe
3. Water sensor pins
4. Serial Number
5. Indicator LED
6. USB Micro-B Port
7. USB Micro-B Dust Cover

Treatment size: 1 liter
Number of treatments per full battery: approx. 20
3 year limited warranty

Directions for Use 40 C.F.R. §156.10(i)(2)(II).
It is a violation of Federal law to use this product in a manner inconsistent with its labeling.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

1. This device may not cause harmful interference, and
2. This device must accept any interference received, including interference that may cause undesired operation.

Note:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

1. Reorient or relocate the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.

Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user authority to operate the equipment under FCC rules.

If the equipment is used in a manner not specified by the manufacturer, the protection provided by the equipment may be impaired.

Do not attempt to bypass water sensor; it is an important safety feature.
Do not handle Steripen with wet hands; do not touch water sensor pins with wet fingers.

This device emits UV light, direct exposure may be harmful.

Do not use UV lamp as a light source.

Do not use near skin, eyes, or insert into bodily orifices.