Advertisement
Quick Links
NOTE
The ML (Medium/Large) size fits most people; the SM
(Small) size is for individuals with very small head sizes.
Assemble and Don Battery and Belt
1. Place a fully charged Battery's over the Belt with the Clip Detent
touching the Clip, Metal-to Metal.
Assemble The Cuff or Shroud to The Helmet
1. Align FCC front TurnClip horizontally, snap
Lens Front Alignment Hole over TurnClip,
place TurnClip vertically locking Lens in place.
Don the Assembled Helmet and Headcover
2. Loosen Headband
1. Connect Power
Ratchet Knob for easy
Cord to Battery.
placement on Head.
Complete Donning
1. Tighten Headband Knob
2. SHROUDS ONLY:
securely comfortable for
Pull Shroud Body down
all activities.
over Shoulders.
Doff and Disassembly
Reverse Donning and Assembly steps.
Disconnect Battery from Helmet Power
Cord
Connect Battery to Charger.
All manuals and user guides at all-guides.com
2. Place the Belt comfortably around the waist
with the Battery near the side-back of the
right hip and lock the buckles together.
2. Snap one Lens Side Attachment
Hole over FCC Side Attachment
Post. Repeat for other side.
3. Pull top edge of Cuff down and
place Chin into Cuff, pull Helmet
down onto Head.
3. FOR DOUBLE SHROUD:
Tuck inner Shroud Body
inside outer Gown.
Ready for Next Use
Dispose of single use items per
institutional protocol for
contaminated waste.
Wipe down all reusable item
surfaces with alcohol based wipes.
CUFF
3. Pull Lens Peel Tab up and
across to remove Lens
Protective Cover from Lens.
4. Slide fingers between Cuff
and face from temples
down to position Cuff.
1
4. With Shroud Body fully
down secure Neck and
Body ties.
SHROUD
2365-02ML
Lens
2365-02SM
Cuff
Lens Protector peel tab
DLC (Disposable Lens Cuff)
2260-05 Single Shroud
2261-01 Double Shroud
≤ 1/2
Inch
(~1.25 cm)
1 Ensure less than one-half inch
between Eyebrows and Helmet
front bottom so Safety LEDs are
easily seen.
FCC Side Tabs
DLC Flappers
1 DLC Flappers must be in front
of FCC Side Tabs
1 Ensure slight tension between
Face and Cuff, or use SM size.
P/N 03523336 Rev B
Advertisement
Related Manuals for Maxair CUFF
Summary of Contents for Maxair CUFF
- Page 1 Battery near the side-back of the right hip and lock the buckles together. DLC (Disposable Lens Cuff) Assemble The Cuff or Shroud to The Helmet 2260-05 Single Shroud 1. Align FCC front TurnClip horizontally, snap 2. Snap one Lens Side Attachment 3.
- Page 2 Disconnect Battery from Helmet Power contaminated waste. Cord Wipe down all reusable item 1 Ensure slight tension between Connect the Battery to a Charger. surfaces with alcohol based wipes. Face and the Cuff, or use SM size. P/N 03523336 Rev B...
Need help?
Do you have a question about the CUFF and is the answer not in the manual?
Questions and answers