Table of Contents
Advertisement
Controls and input connections
A wide variety of external equipment can be connected to the input sockets on the side of the television.
Whilst all the necessary adjustments and controls for the television are made using the remote control, the
buttons on the side of the television may be used for some functions.
INPUT 3
(EXT 3)
Switching on
If the red LED is unlit check that the mains plug is
connected to the power supply. If the picture does not
appear press Standby on the remote control, it may take
a few moments.
To put the television into Standby press
control. To view the television press
may take a few seconds to appear.
To set up the television you will now need to use the
on-screen menus. Press the MENU button on the
remote control to see the menus.
The menu bar at the top of the screens will show five
different topics shown in symbols. As each symbol is
selected by pressing the S or R button on the remote
control, its respective options will appear below.
To use the options press the Q button on the remote
control to move down through them and OK, S or R to
select the required choice. Follow the on screen
instructions. The functions of each menu are described in
detail throughout the manual.
on the remote
i
i
again. The picture
GREEN – On-timer set
RED – Power On
Using the controls and connections
To alter the volume press —
To alter the programme position press
Press MENU and P, Q, S or R to control the sound and
picture options.
Press MENU to finish.
When connecting mono sound equipment to EXT 3,
connect the audio output of the equipment to the
L/Mono socket on the television.
To select the Input, press
EXT3 as described on page 22. The television will
automatically sense the type of signal.
Please always refer to the owner's manual of the
equipment to be connected for full details.
Please note: Inserting the headphone jack will mute the
sound from all speakers.
8
Standby
+
.
j
e e
f f
.
F
B
until the display shows
Advertisement
Table of Contents
