Table of Contents
Advertisement
7.0 TROUBLESHOOTING & WARRANTY
PROBLEM
Unit does not turn on
The meter displays 99.9 at all times.
"LOBAT" is displayed
Hay moisture meter will not display 00.0
in open air.
OR
Open air reading of 8.0 is displayed.
Temperature not readings accurate.
Unit reading inaccuratley
WARRANTY
Farmscan Pty Ltd "Farmscan" guarantees to correct by repair or parts replacement, without
charge, any defect arising from faulty workmanship or materials.
The period of this guarantee is (1) one year.
Farmscan Guarantee is subject to the following conditions:
• Faulty equipment must be returned to Farmscan or an authorised repair center at the
owner's expense and at the owner's risk.
• If gurantee valid, Farmscan may pay the cost of return freight using its nominated carrier at
owner's risk.
• Commencement date of Guarantee will be from date of registration on the warranty card.
• Guarantee card must be lodged within ten days of purchase for registration to be accpeted.
• Equipment returned for repair that is not registered for guarantee purposes will have the
guarantee period calculated from the original date of despatch from Farmscan.
• Repairs to equipment will be charged if the guarantee period has expired of if fault caused
by damage or misuse.
• If equipment is tampered with by unauthorised persons, then this guarantee is void.
• Our full warranty & liability statement is available on request or on our website:
www.farmscan.com.au.
DOCU-M0106 05-10
POSSIBLE CAUSE/ REMEDY
Check battery is connected properly.
Clean probe tip and calibrate moisture
meter.
Replace the battery with a new 9 Volt
Alkaline battery. Re-calibrate moisture
meter.
Clean probe tip and calibrate moisture
meter
Make sure you allow the metal tip of the
probe to adjust to the bale temperature.
This can take a minute or two.
Calibrate Unit.
7
AM-2188 v4 09-19
Advertisement
Table of Contents
