Grouping Mode ] - Uni-bond E-916 Series Installation Manual

Synchronization Manual
E-916 Series LED Warning Lights
These lights can be synchronized to flash simultaneously or alternately. To flash alternately,
you must determine which group each light will be in. You need not have the same number
of lights in each group. To sync simultaneous, all lights must be in the same group.
[
Grouping Mode
This is a built-in mode that lets you set your groups for syncing
Steps below must be done before installing/mounting the lamp for use
Determine the Sync Group you want for your set-up
Connect the Black wire to Ground. Connect White wire & Brown wire at the same time to a power
[
source to enter Grouping Mode
Simultaneous Sync:
[
• In Grouping Mode
(Brown wire) to the power source and SET EACH LAMP TO THE SAME GROUP
[
- refer to Grouping Mode
Disconnect the power source to exit [ Grouping Mode ].
•
Re-connect only the White wire to the power source. Briefly tap Pattern Selection
•
(Brown wire) to the power source to change patterns
- refer to (
1.1 Flash Patterns
Once all lamps are set to the same patterns, connect all Brown wires together.
•
Alternating Sync:
[
In Grouping Mode
•
(Brown wire) to the power source and SET LAMPS TO EITHER GROUP 1 or GROUP 2
[
- refer to Grouping Mode
Disconnect the power source to exit [ Grouping Mode ].
•
• Re-connect only the White wire to the power source. Briefly tap Pattern Selection
(Brown wire) to the power source to change patterns
- refer to (
1.1 Flash Patterns
Once all lamps are set to the same patterns, connect all Brown wires together.
•
For Wiring & Flash Patterns - (
]
Single Flash = Group 1
]
.
Lamp units will only flash together if in the same group
]
, the lamp will be blinking dimly. Briefly tap Pattern Selection
]
above
) of Installation Manual
Lamp units in Group 1 will flash alternately with lamp units in group 2
]
, the lamp will be blinking dimly. Briefly tap Pattern Selection
]
above
) of Installation Manual
For more information, visit our website at: www.unibondlighting.com
Double Flash = Group 2
refer to Installation Manual
)