Auto Mute Mode; Muting An Alert - Cobra ESD 9560 Operating Instructions Manual

3
O P E R AT I O N • S E T T I N G S
™
Setting the SmartMute
Activation Point
Your ESD-9560 must be installed in
your vehicle.
1.
Procedure
In Program mode, go to Set
SmartMute. Press and release the
SET/CITY button to begin
setting SmartMute™ .
2.
Procedure
Rev your engine to the level you
wish to set. Rev the engine
slightly above idle and hold revs
steady for 2 seconds.
NOTE: If the unit is unable to sense
usable pulses within three seconds,
SmartMute™ will indicate an error and
automatically turn off.
3.
Procedure
At the desired rev level,
press and release the
SET/CITY button.
NOTE: If you do not set a rev point
within 20 seconds of beginning these
steps, SmartMute™ will indicate an
error and automatically turn off.
4.
Procedure
Press and release either the
SELECT/DIM button to proceed
to the next user mode or the
PROG/MUTE button to exit the
Program mode.
10
Caution: Do not attempt to set the rev
point while driving. Your vehicle should
be parked and idling.
SmartMute™ must be turned on.
Tone Visual Display
2 beeps Press SET again at
desired RPMs...
Press SET again...
Tone Visual Display
none none
1 beep Error
Tone Visual Display
SmartOff
1 beep
appears
SmartOff
Tone Visual Display
3 beeps Smart
Smart
then
SET!
1 beep Error
Tone Visual Display
SmartOff
1 beep
appears
SmartOff
Tone Visual Display
none none

Auto Mute Mode

Auto Mute will automatically reduce the
audio volume of all alerts after 4 seconds
for as long as the signal is detected. When
you turn Auto Mute on or off you will hear
2 beeps for Auto Mute on and 1 beep for
Auto Mute off.(See page 7 for instructions
on using the Program mode to select
Auto Mute.)
The factory setting for Auto Mute is ON.
Err or
SET!
Err or
O P E R AT I O N • S E T T I N G S

Muting an Alert

Your ESD-9560 allows you to quickly
turn off an audio alert by momentarily
pressing and releasing the PROG/MUTE
button. If you press and release the
PROG/MUTE button a second time
during the alert, the audio alert will be
turned back on.
PROG/MUTE button
Press and release
Auxiliary Audio Jack
Use to connect an external speaker in
environments with high ambient noise
levels. The internal speaker will be
disconnected.
11
3