General - Sony SAT-W60 Service Manual

The instructions mentioned here are partial abstracts from the Operating Instruction Manual.
The page numbers shown reflect those of the Operating Instruction Manual.
Satellite Receiver
Step 1: Connecting the Antenna
Satellite Receiver
Connect the SATELLITE IN jack
1
to your Satellite Dish Antenna
using RG-6 coaxial cable.
Connect the 2nd signal if you
2
have Dual LNB. Advance Set
Up for dual output.
Step 2: Connecting Your Phone Line
Satellite Receiver
1
10
All manuals and user guides at all-guides.com
SECTION 1
1 2
Connect the TELEPHONE
1
LINE jack to a telephone
line wall jack using the
supplied telephone cord.

GENERAL

Step 3: Connecting Your TV Set
Satellite Receiver
1c 1a
1b
If your TV has A/V input jacks
1a
Connect the VIDEO OUT jacks on your Satellite Receiver to the
A/V input jacks on your TV using the supplied A/V cable. (Be sure to match the
colors on the jacks with the colored plugs on the A/V cable.) If your TV has only
one audio input, connect it to the L(MONO) jack on the Satellite Receiver.
If your TV has an S-Video input
1b
Use an S-Video cable instead of the yellow video connection. S-Video cable is
supplied.
If your TV does not have A/V jacks
1c
Connect the VHF/UHF OUT jack to the VHF/UHF input jack on your TV using
coaxial cable. Set the CH3/CH4 switch to the channel that does not carry off-air
broadcasts in your area.
Note
With this connection, your input source
is channel 3 or channel 4 depending on
how you set the CH3/CH4 switch on the
Satellite Receiver.
Connecting Your Satellite Receiver
TV
VHF / UHF
IN
VIDEO 1 VIDEO 2
S VIDEO
VIDEO
L
(MONO)
AUDIO
R
11