Ebyte E150-400T30S User Manual page 26

Chengdu Ebyte Electronic Technology Co.,Ltd.
WOR cycle
preamble length
Timing reset time
Low airspeed optimization
Reset AUX indication
DEBUG mode
key
Note:
1. During debugging, if you can't judge why the module can't work normally, you can turn on debug mode, and
then turn off this mode after debugging.
2. In debug mode, the serial port will only print out the completed actions of some modules, which will not
affect the normal execution of the program.
3. The aux timing in the debug mode may be different from that in the non debug mode. The debug mode can
only be used during customer debugging.
4. When the debug mode is enabled, the upper computer will not be compatible. At this time, it needs to use
00 06 0b 7e 00 00 EA 27 command to close it.
5. When the Modbus address is 00 (public address), the local module can be directly operated.
6. Disable the remote configuration mode to sleep mode (mode 2). Once the remote module enters sleep mode,
it can only be awakened through the local serial port.
7. Data RSSI is only valid in transparent data
8.When the channel is the same and the network ID is different, communication cannot be performed, but mutual
interference will occur.
Copyright ©2012–2022，Chengdu Ebyte Electronic Technology Co.,Ltd.
holding register
0x0B79
RW
holding register
0x0B7A
RW
holding register
0x0B7B
RW
holding register
0x0B7C
RW
holding register
0x0B7D
RW
holding register
0x0B7E
RW
holding register
0x0B7F
RW
0x0002: Medium
0x0003: low
Default：2000 ms
0x0000:500 ms 0x0001:1000 ms
1 0x0002:1500 ms 0x0003:2000 ms
0x0004:2500 ms 0x0005:3000 ms
0x0006:3500 ms 0x0007:4000 ms
Default：0 ms
0x0000:500 ms 0x0001:1000 ms
0x0002:1500 ms 0x0003:2000 ms
1
0x0004:2500 ms 0x0005:3000 ms
0x0006:3500 ms 0x0007:4000 ms
0x0008: 0 ms
On by default
1
Default reset time: 5 min
1 Unused
AUX indication at RF reset
1
0x00: off (default) 0x01: on
DEBUG mode
1
0x00: off (default) 0x01: on
Unreadable, the read result is
1
fixed to 00
E150-400T30S user manual
0x03、0x06、
0x10
0x03、0x06、
0x10
0x03、0x06、
0x10
0x03、0x06、
0x10
0x03、0x06、
0x10
0x03、0x06、
0x10
0x03、0x06、
0x10
25