Setup Tab - Network Settings; Figure 5-3: Setup - Network Settings - Linksys SRW2008 User Manual

WebView Switches
PoE Information
NOTE: The PoE Information only appears on the summary screen of the SRW2008P and
SRW2008MP.
Maximum Available Power. Indicates the maximum amount of power the device can supply.
System Operation Status. Indicates whether the PoE function is on or off.
Main Power Consumption. Displays how much power is currently used.

Setup Tab - Network Settings

The Network Settings screen allows you to assign DHCP or static IP settings to interfaces and assign default
gateways.
Identification
System Name. This field allows you to assign a system name.
System Location. This field is used for entering a description of where the Switch is located, such as 3rd floor.
System Contact. Enter the administrative contact person in this field.
System Object ID. The system object identifier is displayed here.
Base MAC Address. This is the MAC address of the Switch.
IP Configuration
Management VLAN. This drop-down allows you to select the Management VLAN.
IP Address Mode. This drop-down allows you to select Static or Dynamic IP address configuration.
Host Name. Enter the DHCP Host Name here.
IP Address. If using a static IP address, enter the IP address here.
Subnet Mask. Enter the subnet mask of the currently configured IP address.
Default Gateway. Enter the IP address of the Default Gateway.
Chapter 5: Using the Web-based Utility for Configuration
Setup Tab - Network Settings

Figure 5-3: Setup - Network Settings

29