The Back Panel; Figure 2-3: Back Panel Of The Srw2008P - Linksys SRW2008 User Manual

WebView Switches
Use the Linksys MGBT1, MGBSX1, or MGBLH1 mini-GBIC modules with the Switch. The
MGBSX1 and the MGBLH1 require fiber cabling with LC connectors, while the MGBT1
requires a Category 5e Ethernet cable with an RJ-45 connector.
Console The Console port is where you can connect a serial cable to a PC's serial port for
configuration using your PC's HyperTerminal program. Refer to Chapter 4: Using the
Console Interface for Configuration for more information.

The Back Panel

The power port is located on the back panel of the Switch.

Figure 2-3: Back Panel of the SRW2008P

Power The Power port is where you will connect the power cord.
NOTE: If you need to reset the Switch, unplug the power cord from the back
of the Switch. Wait a few seconds and then reconnect it.
Chapter 2: Getting to Know the Switch
The Back Panel
7