Maintenance; Specifications - LENCO SCD-24 Instruction Manual

MAINTENANCE

CLEANING A CD
If the CD skips or will not play , the disc may need cleaning
. Before playing, wipe the disc from the centre out with a
cleaning cloth. After playing, store the disc in its case.
CLEANING THE CD LENS
If the CD lens is dusty, clean it with a brush-blower. Blow
several times on the lens and remove the dust with the
brush. Finger prints may be removed with a cotton swab
moistened with alcohol.

SPECIFICATIONS

CD
S/R ratio:
Sample frequency:
Quantization:
Laser wavelength:
Radio
Frequency range:
Antenna:
General
Input voltage:
Power consumption:
Output power:
Speaker size:
Speaker impedance:
Phones output:
Battery specification:
Dimensions:
Weight:
Commaxx International reserves the right to change the contents of this document without notice.
CLEANING THE UNIT
Do not use volatile chemicals on this unit. Clean by lightly
wiping with a soft cloth.
IMPORTANT NOTE
If an abnormal display indication or an operating problem
occurs, disconnect the AC power cord and remove the
batteries. Wait at least 5 seconds, then reconnect the AC
power cord or reinstall the batteries.
WARNING
Should the CD door be opened before the reading of the CD
is completed, a jamming noise may occur. This is resolved
by closing the CD door.
58 dB
44.1 kHz 8x oversampling
1 bit DA converter
790 nm
FM: 87.5 - 108Mhz
Telescopic
AC 230V- 50Hz
13.5W
1W + 1W (RMS)
3"
8 Ohm
3.5mm Jack
6x 1.5V LR14/C/UM2
224 x 234 x 126mm (wxdxh)
1.45Kg
GB 5