Advertisement
Mounting Hole Specifications/ Xenon Bulb Replacement lnstructions
■ Mounting Hole Specifications
• Machine holes on the mounting surface referring to
the diagram below.
3-Ø6 HOLES
Min.
Ø5 CABLE ENTRY
PCD 96
S150US/ S150UHS
3-Ø6 HOLES
Min.
Ø5 CABLE ENTRY
■ Xenon Bulb Replacement instructions
S150US/ S150US-FT
PCD 155
Disassemble
bulb
• Please wait at least 30 mimutes after turning off the power before replacing the xenon bulb.
• Please pull out the entire xenon bulb structure
•For xenon bulb assembly, please ensure the connector portion of the xenon bulb structure matches the pin location
Installation Environment and Protection Rating
• This product is designed for use with protection rating of IP44.
• If the product is installed in locations that subject it to excessive dust or water other than the designated IP protection rating
indicated(IP44), it may cause malfunction or damage to the product.
• In case of outdoor applications, install the product in the upright position. Do not install the product horizontal or upside-
down positions where water can potentially penetrate into the product and impact it's operation.
• For further information, please visit our website (www.qlight.com).
①
Assemble
bulb
②
to disassemble.
①
Min.
Ø5 CABLE ENTRY
PCD 96
3-Ø6 HOLES
Min.
Ø5 CABLE ENTRY
PCD 155
S150US-FT/ S150UHS-FT
S150UHS/ S150UHS-FT
Disassemble
bulb
3
①
Assemble
bulb
②
②.
Advertisement
