Preparing Tractor For Mixer; Before Operation - Farm Aid 500 Owner's Manual

PREPARING TRACTOR FOR MIXER

PTO:
IMPORTANT: Mixers are designed to operate at a maximum of either 540 or
1,000 rpm. The PTO shafts are different for the different configurations. The 540
RPM configuration has 6 protruding teeth in the PTO connection while the 1,000
RPM configuration has 21. Only install what fits the tractor you are powering the
mixer with. Do not use an adapter.
DRAW BAR/HITCH ADJSUTMENT:
 If featured with an offset drawbar, turn down.
 Adjust drawbar length so that from the end of the PTO shaft to the center of the
hitch pin hole it is 14" on a 540 RPM or a 1,000 RPM PTO.
 With mixer attached to the tractor determine if the hitch needs to move to a
higher or lower position to make the mixer frame approximately parallel with the
ground.
 If the hitch needs adjustment, then using the jack, support the empty mixer,
remove the hitch pin, move the tractor forward, and adjust the height of the hitch.
REMEMBER
Your best assurance against accidents is a careful and responsible operator. If
there is any portion of this manual or function you do not understand, contact
your dealer or Farm Aid Equipment.

BEFORE OPERATION:

Carefully study and understand this manual.
Do not wear loose-fitting clothing which may catch in moving parts.
Always wear protective clothing and substantial shoes.
Keep wheel lug nuts or bolts tightened to specified torque.
Make sure the tires are inflated properly.
Give the unit a visual inspection for any loose bolts, worn parts or cracked welds,
and make necessary repairs. Follow the maintenance safety instructions included
in this manual.
Do not use the unit until you are sure that the area is clear of people, especially
children and animals.
Practice operation of your mixer/feeder and its attachments. Completely
familiarize yourself and other operators with its operation before using.
Do not allow anyone to stand between the tongue or hitch and the towing vehicle
when backing up to the mixer/feeder.
Be sure all shields are in place before operation.
FARM AID EQUIPMENT, INC. 40 EAST 1ST STREET, CORSICA, SD 57328
PHONE (605) 946-5479 FAX (605) 946 5899 www.farmaidequip.com