Exit; Troubleshooting; Common Problems And Solutions - Linksys EF1324 User Manual

Instant etherfast series etherfast layer 3 management 24-port 10/100 + 2-port gigabit ethernet switch

Hide thumbs Also See for EF1324:

Table of Contents

Enlarged version

Exit

The Exit command under the Main Menu is used to exit the configuration pro-

gram and terminate communications with the Switch for the current session.

If you need to return to the program, press Enter repeatedly.

114

Instant EtherFast

Series

EtherFast

Layer 3 Management 24-Port 10/100 + 2-Port Gigabit Ethernet Switch

This section provides possible solutions to problems regarding the installation

and operation of the Managed 24-Port with Dual Gigabit Switch. If your situ-

ation is described here, the problem should be solved by applying the corre-

sponding solution. If you can't find an answer here, check the Linksys website

at www.linksys.com.

1. I can't connect to the Managed 24-Port with Dual Gigabit Switch using the

telnet, Web browser, or SNMP software.

• Be sure you have configured the agent with a valid IP address, subnet mask,

and default gateway (Layer 2).

• Check that you have a valid network connection to the Switch and that the

port you are using has not been disabled.

• Check the network cabling between the management station and the Switch.

• If you cannot connect using telnet, there may already be four active sessions.

Try connecting again at a later time.

2. I forgot or lost the password.

• Reinstall the switch firmware as described in the Appendix. Otherwise, con-

tact Linksys Technical Support for help.

115

Table of Contents