4-Port Gigabit Security Router with VPN
Appendix F: Physical Setup of the Router
This section describes the physical setup of the Router, including the installation of the mounting brackets.
Setting up the Router
You can set the Router on a desktop or mount it on the wall.
Placement of the Router
Set the Router on a desktop or other flat, secure surface. Do not place excessive weight on top of the Router.
Wall-Mount Option
You will need 2 suitable screws (See Figure F-1) to mount the Router.
1. Determine where you want to mount the Router. Ensure that the wall you use is smooth, flat, dry and sturdy
and make sure the location is within reach of the power outlet.
2. Drill two holes into the wall.
Make sure the holes are
64.5mm apart.
3. Insert a screw into each hole,
and leave 3 mm of its head
exposed.
4. Maneuver the Router so the
wall-mount slots line up with
the two screws.
5. Place the wall-mount slots
over the screws and slide the
Router down until the screws
fit snugly into the wall-mount
slots. Congratulations! The
Wall-Mount installation of the
Router is complete.
Appendix F: Physical Setup of the Router
Setting up the Router
Print this page at 100% size, cut along the dotted line
and place on the wall to drill precise spacing.
Figure F-2: Wall-Mounting Template
Figure F-1: Suggested Mounting Hardware
Figure F-3: Wall-Mounting the Router
79