Advertisement
Quick Links
BEFORE YOU BEGIN
• Please read these instructions carefully to familiarize
yourself with the required tools, materials, and installation
sequences. Follow the sections that pertain to your
particular installation. This will help you avoid costly
mistakes. In addition to proper installation, read all
operating and safety instructions.
• All information in these instructions is based upon the latest
product information available at the time of publication.
Kohler China reserves the right to make changes in product
characteristics, packaging, or availability at any time
without notice.
• These instructions contain important care, cleaning, and
warranty information - please leave instructions for the
consumer.
TECHNICAL INFORMATION
A. Specifications
Dimensions
W × H × D
Soap Tank Capacity
Battery
Pre-Set Sensing
Range
Room Temperature
Sensing Delay Time
Dispensing Time
Dispensed Soap
Quantity
Applicable Liquid
Soap Viscosity
Battery Duration
NOTE
Only use the liquid soap dispenser for liquid soap,
otherwise the dispenser will be blocked or unable to
dispense.
KOHLER CHINA INVESTMENT CO., LTD
科勒（中国）投资有限公司 上海市静安区江场三路158号 邮编：200436
1343543-T01-A
296 × 117 × 133mm
(11.65" × 4.6" × 5.23")
1000ml
4 pcs of Alkaline AA (1.5V)
15 ± 3cm
5℃~40℃
1 sec
1 sec
about 1.0ml
1~3500mPa·s
15,000 cycles
JING'AN DISTRICT, SHANGHAI, PRC
安装之前
• 请小心详阅本指引，以便熟悉所需工具、物料及安装程序。
请遵照适用的章节来安装你的产品，以避免由于安装不当而
导致不必要的损失。除了有关正确的安装方法之外，还务必
请详阅所有操作及安全指引。
• 本指引所载之一切资料，均以印刷时所有之最新产品情况为
基础， 科勒中国保留权利随时更改产品特性、 包装或供应情况，
恕不另行通知。
• 本指引也包含了有关护理、清洁及保养等重要资料，请交予
用户留存。
技术资料
A.
规格说明
外型尺寸
W × H × D
皂筒容量
输入电源型式
出厂感应距离
适用环境温度
感应时间
给皂时间
出皂液量
适用皂液粘度
电池使用寿命
注意
液体型给皂器只能装液体型洗手液，否则会造成阻塞给皂器。
NO.158, JIANG CHANG SAN ROAD,
POST CODE: 200436
-1-
© Copyright Kohler China Investment Co., Ltd. 2018
© 版权为科勒（中国）投资有限公司所有 2018
BARDON 巴尔顿
INSTALLATION INSTRUCTIONS
安装说明书
SOAP DISPENSER
自动感应液体给皂器
K-5487T-B/K-5487T-XB
296 × 117 × 133mm
(11.65" × 4.6" × 5.23")
1000ml
AA (1.5V)
碱性电池
4
节
15 ± 3cm
5℃~40℃
1秒
1秒
约1.0ml
1~3500mPa·s
15,000次
Advertisement
Related Manuals for Kohler BADRON K-5487T-B
Summary of Contents for Kohler BADRON K-5487T-B
- Page 1 • 本指引所载之一切资料，均以印刷时所有之最新产品情况为 基础， 科勒中国保留权利随时更改产品特性、 包装或供应情况， product information available at the time of publication. 恕不另行通知。 Kohler China reserves the right to make changes in product characteristics, packaging, or availability at any time without notice. • 本指引也包含了有关护理、清洁及保养等重要资料，请交予 • These instructions contain important care, cleaning, and 用户留存。...
-
Page 2: Standard Installation
B. Item List 包装明细表 Illustration Description Q'ty Illustration Description Q'ty 图示 品名 数量 图示 品名 数量 3pcs Plastic Dowel 钥匙 膨胀螺丝套 把 颗 Installation Fixing Screw 3pcs Instruction 份 固定螺丝 颗 安装及使用说明书 Battery AA 1.5V 4pcs Cut-out Template 张 碱性电池 AA 1.5V 节... -
Page 3: Before Installation
安装之前 BEFORE INSTALLATION NOTES 注意 1. Check if surface of wall is smooth and clean. 请检查墙面是否平整，同时将墙壁擦拭干净。 2. Distance between sensor and 感应器下方须距离反光物或台面250mm以上。 否则会造成感应器持续工作，无法正常使用。 bench-top should be ≥ 250mm. Min 250mm （如图所示） Otherwise, the sensor will continue 最低 250mm to work and be damaged. (shown as figure) 安装... -
Page 4: Installation Check
5. Insert three fixing screws into plastic dowels and tighten them, but maintain a 3mm space from the wall for hanging the dispenser. (Fig.4 and Fig.5) 将三颗固定螺丝对准先前安装的膨胀螺丝套并拧入，并注意拧入时 必须保留3mm的长度，以方便机器挂住。（如图4、图5） Fig.4 图4 6. Hang the dispenser on three screws by the back plate holes of the dispenser, then tighten them with screwdriver. - Page 5 3. In filling liquid soap, use key to remove the soap dispenser lid. Uncover the container lid to pour liquid soap into the bottle. Notice: Should the dispenser be out of order and do not attempt any repair work. Call Kohler China for professional assistance. 3. 补充皂液时，利用钥匙将给皂器上盖打开，揭开瓶盖，...
-
Page 6: Important Notice
E. Important Notice 维护保养及注意事项 1. 感应器下方避免有直接光源存在。 1. Ensure no light source is aimed at the sensor from below. 2. 感应器下方避免有反光物；或者必须距离反光物 250mm 以上。 2. Ensure that no light reflection occurs through any object within a distance of 250mm below the sensor. 3.