Advertisement
Copyright By SRC
Design and Specification are subjected to change
Mounting Instructions
As show RH motorbike
As show RH motorbike
Before installation,
remove the original Guard
and original crash bar (as
show)
As show LH motorbike
Orient the Bracket RH (2)
and slip-in the Bush RH (7)-1
off, the washer M10 (13) – 1
off, the long bolt M10x95
(12)-1 off,
Orient the Bracket Lower (4)
and slip-in the taper ring
(15) – 1 off, the screw
M8x30 (10) – 1 off,
And tighten it to torque as
shown in the BOM table.
Page 2
Advertisement
