Advertisement
Copyright By SRC
Design and Specification are subjected to change
As show LH motorbike
As show RH motorbike
Orient the Bracket LH (3)
and slip-in the Bush LH (6)-1
off, the washer M10 (13) – 1
off, the long bolt M10x115
(11)-1 off,
Orient the Bracket Lower (4)
and slip-in the taper ring
(15) – 1 off, the screw
M8x30 (10) – 1 off,
And tighten it to torque as
shown in the BOM table.
Orient the Engine Guard (1)
Bracket Front (5) at front
side in motorbike and slip-in
the Taper Ring M6 (14) – 2
off, the screw M6x20 (9) – 2
off,
Slip-in the Taper Ring M6
(14) – 2 off, the screw
M6x15 (8) – 2 off,
And slip-in the Taper Ring
M6 (14) – 2 off, the screw
M6x15 (8) – 2 off, at the end
side
And tighten it to torque as
shown in the BOM table.
Page 3
Advertisement
